Gluing instructions
ALFABET and TIERIG
decal for IKEA LÄTT high chair
Made in Germany
⚠️ ATTENTION!
- All wall/play films are suitable for children aged 3 and over and for indoor use only. If you do not apply the film immediately, please keep it out of the reach of children. It may only be used by children once it has been applied.
- The film may only be applied to furniture with a sufficient surface area. The film must not protrude beyond the furniture.
- If a corner of the film no longer adheres due to repeated peeling, the piece of furniture no longer fulfils the safety requirements and must be taken out of circulation.
- If the film is removed and reapplied to another wall or another piece of furniture, the piece of furniture no longer fulfils the safety requirements due to changes in the adhesive properties and must be removed from circulation .
Fitting instructions
1. Dismantling & cleaning the chair
If you have an already assembled LÄTT high chair, you should disassemble the chair before laminate. This will give you a clean result, as the edges of the decal disappear under the chair frame. To do this, loosen the two rear screws so that you can remove the chair backrest and pull out the seat.
The seat should be clean and free of dust and grease before laminate. Therefore, clean it thoroughly and then dry it with a cloth.
2. Remove the corner
First, carefully remove one corner of the film from the backing paper and align it with the seat.
3. Stick on the film
Now hold the film at two corners and stick it slowly onto the surface to be covered. If bubbles appear or you have stuck yourself down, you can slowly and carefully remove the film at a 45° angle and reposition it.
4. Assembling the chair
You can now reassemble the chair. To do this, carefully push the glued seat back into the chair frame. Now assemble the chair backrest and screw it back on with the 2 screws.
