Mounting instructions

decal for IKEA DUKTIG play kitchen

Made in Germany

CE Zeichen

⚠️ ATTENTION!

  • All wall/play films are suitable for children aged 3 and over and for indoor use only. If you do not apply the film immediately, please keep it out of the reach of children. It may only be used by children once it has been applied.
  • The film may only be applied to furniture with a sufficient surface area. The film must not protrude beyond the furniture.
  • Our play foils may only be used under adult supervision and should be checked for any damage before use. The play furniture must NOT be used if parts are damaged.
  • If a corner of the film no longer sticks due to repeated peeling, the toy no longer fulfils the safety requirements and must be taken out of circulation.
  • If the film is removed and reapplied to another wall or another piece of furniture, the toy no longer fulfils the safety requirements due to changes in the adhesive properties and must be removed from circulation .

What you need:

  • Chipboard (32 x 67.5 cm) as backsplash. You can buy it for 2-3 euros in DIY stores.
  • Small nails
  • Hammer

Mounting instructions

1. Preparation

Unscrew the handles from the play kitchen and put everything to one side so that you can refit them later.
Now loosen the screws at the top of the play kitchen and remove the cover. Now you can pull out the upper part of the backsplash. This makes it easier to stick the compartments next to the microwave.
Your IKEA furniture should be clean and free of dust and grease before laminate. Therefore, thoroughly clean all furniture surfaces to be covered and then dry them with a cloth.
Kinderkueche Deckel lösen
Kinderküche Deckel lösen
Kinderkueche Deckel lösen

2. Remove the backing paper

Small pieces can be removed from the backing paper immediately. For large pieces of film, only peel off a strip of backing paper approx. 10 cm wide to begin with. This will prevent the large adhesive surface from sticking to another adhesive surface and make it easier to apply. It is best to apply large surfaces together with a second person .

Tip: To make things easier, carefully cut the individual stickers apart with scissors to make them easier to stick.

Klebefolie lösen

3. Position the film

Now hold the film at two corners and slowly apply it to the surface to be covered. If bubbles appear or you have stuck yourself down, you can slowly and carefully remove the film at a 45° angle and reposition it.
Tip: Our films are slightly smaller than the IKEA furniture surface so that nothing protrudes on either side and alignment is easier for you. Please bear this in mind when applying.
Kinderkueche bekleben

4. Stick on the film

You can now peel off the backing paper piece by piece and stick on the film. Use your hand or a cloth to smooth out the film and press out any bubbles.
Stick the top backsplash with the 2 smaller adhesive foils, as shown on the backing paper, to the left and right of the top edge of the back side.
kinderkueche bekleben anleitung

5. Fasten the splash guard

Now fix the chipboard to the back side of the play kitchen using a hammer and small nails.
spritzschutz befestigen

6. Fasten the handles and lid

Next, slide the upper backsplash back into the play kitchen. Place the lid on top and screw it back on tightly.

To reattach the handles, use a screwdriver to poke through the film into the existing holes. Now you can screw the handles on as usual.

Kinderküche Griffe montieren

Removal instructions

We have the following tip for you for removing the film from the furniture: Heat the film with a hairdryer and peel it off carefully and slowly at a 45° angle. Please note that we have no information about the condition of the furniture or your wall. It can therefore not be ruled out that colours, wallpaper, paintwork or other surfaces may be damaged when the film is removed.

Do you have any questions?