Mounting instructions

Trofastbox accessories

Made in Germany

⚠️ ATTENTION!

All wall/play films are suitable for children aged 3 and over and for indoor use only. If you do not apply the film immediately, please keep it out of the reach of children. It may only be used by children once it has been applied.
the film may only be applied to furniture with a sufficient surface area. The film must not protrude beyond the furniture.
Our play foils may only be used under adult supervision and should be checked for any damage before use. The play furniture must NOT be used if parts are damaged.
If the film has been completely or partially removed and re-glued, the toy no longer fulfils the safety requirements due to altered adhesive properties and must be taken out of circulation.

Application instructions

1. Prepare the adhesive surfaces & remove the corner

The lid for the TROFAST box should be clean and free of dust and grease before laminate. Therefore, clean the surfaces to be glued thoroughly and then dry them with a cloth. To begin with, please only remove an approx. 10 cm wide strip of the backing paper. This will make sticking easier.

2. Positioning & applying the film

Note: At DÄCKEL you should leave a minimum distance to the edge so that the film is centred.

With the original TROFAST lid, you should remove the circle in the centre of the decal before laminate.

Now hold the film firmly at two corners and stick it slowly onto the surface to be covered. If bubbles appear or you have stuck, you can slowly and carefully remove the film at a 45° angle and reposition it.

Tip: If you have the DÄCKEL, you can use it from both sides laminate.

Do you have any questions?

Write to us!